Home >

 

Altronix AX-AL1024ULA Access Power Controller with Power Supply



Altronix AX-AL1024ULA Access Power Controller with Power Supply


 

Our Price : $483.16


Product Code: 51341

Qty:

Description
 

Access Power Controller with Power Supply

This unit distributes and switches power to access control systems and accessories. It converts a 115VAC 60Hz input into eight (8) independently controlled 12VDC or 24VDC PTC protected outputs. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. The unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

UL Listed - US and Canada for Access Control Systems (UL294).
MEA - NYC Department of Buildings Approved.
Power supply input options:
a)One (1) common power input for ACM8CB and lock power (factory installed).
b)Two (2) isolated power inputs (external power supply is required).
(current is determined by the power supply connected, not to exceed a maximum of 10 amp total).
Eight (8) Access Control System trigger inputs.
Input options:
a)Eight (8) normally open (NO) inputs.
b)Eight (8) open collector inputs.
c)Any combination of the above.
Eight (8) independently controlled Fail-Safe and/or Fail-Secure power outputs.
Eight (8) auxiliary power outputs (unswitched) (PTC protected outputs are rated 2.5 amp).
ACM8 board main fuse is rated at 10 amp.
Red LEDs indicate outputs are triggered (relays energized).
Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
Fire Alarm disconnect input options:
a)Normally open (NO) or normally closed (NC) dry contact input.
b)Polarity reversal input from FACP signaling circuit..
Alarm output relay indicates that FACP input is triggered (form ?C? contact rated @ 1 amp 28VDC not evaluated by UL).
Green LED indicates when FACP disconnect is triggered.
Filtered and electronically regulated outputs (built-in power supply).
Built-in charger for sealed lead acid or gel type batteries.
AL1024ULXB (Power Supply Board) maximum charge current 3.6 amp.
Automatic switch over to stand-by battery when AC fails.
Zero voltage drop when unit switches over to battery backup (AC failure condition).
Thermal and short circuit protection with auto reset.
AC input and DC output LED indicators.
AC fail supervision (form "C" contact).
Battery fail and battery presence supervision (form "C" contact).
Enclosure accommodates up to two (2) 12AH batteries.
Enclosure dimensions: 15.5"H x 12"W x 4.5"D

Share your knowledge of this product with other customers... Be the first to write a review
 
 

Enter your email for a chance to WIN $100 Amex Gift Card.

Please Enter Your Email Address

*One entry per household please