AvaLAN AW900x - Outdoor 900 MHz Ethernet Bridge Kit

The AW900x replaces costly wiring with a wireless Ethernet bridge that can enable remote Wi-Fi APs, Ethernet pan/tilt/zoom security cameras, VoIP phones or Internet Kiosks. AvaLAN’s product offers the ideal combination of price, range, data rate, security, interference avoidance, quality-of-service and ease-of-use.

Long-range 900MHz wireless outdoor Ethernet bridge.

Kit includes:

• 2 x AW900x NEMA-4x radios
• 2 x 110-220 VAC to 9 VDC power supplies
• 2 x 30ft outdoor grade CAT5 cables
• 2 x Power over Ethernet injectors
• 2 x wall mounting kits.

Features:

• Foliage penetrating, non-line-of-sight wireless Ethernet bridging.
• Does not interfere with Wi-Fi networks.
• Highest Quality of Service (QoS) available - Synchronous point to point protocol enables extremely low data latency and jitter.
• 128bit encrypted payload protection provides secure data delivery.
• Simple plug and play - pre-configured as matched pairs with no user programming required.
• Power over Ethernet Enabled
• Operates in the 902-928MHz band and does not require an FCC license to operate or install.
• VLAN extensions supported.

Benefits:

The AW900x is the best solution when:
• a Broadband Ethernet drop will cost too much or is impractical to install
• Wi-Fi is too slow due to saturation or 2.4 GHz interference (airport/mall/ PTZ cameras)
• guaranteed DSL-rate throughput is required (kiosks/Wi-Fi APs/PTZ cameras)
• guaranteed latency for voice or video is required (VoIP/PTZ cameras)
• an indoor long-range broadband backhaul is required
• ultra-low current consumption is required — (1 Watt/solar powered systems)

Available Antennas:

• 2.5 dBi
• 11 dBi
• 15 dBi

Non-line-of-sight range:

• Up to 10x the range of Wi-Fi (with 15 dBi directional antennae)
• More than 2miles with 4 trees (with 2.5 dBi omni-directional antennae)

Line-of-sight range (clear Fresnel zone):

• More than 40 miles (with 15 dBi directional antennae)

Specifications:

• RF transmission rate: 1.536 Mb/s
• Ethernet throughput : 935 Kb/s
• Output power : +21 dBm (4 Watts EIRP used with 15 dBi antenna)
• Receive sensitivity : -112 dBm at 10e-4 BER with 15 dBi antenna
• Latency : < 2 ms — assuming a dedicated wireless link to client device
• Jitter : +0.5 ms — depending on packet size, interference, and SNR
• Power consumption : FX 0.6 W, TX 1.4 W
• Voltage : 4 to 48 VDC
• Radio channels : 12 non-overlapping
• Automatic frequency select : Yes — radio channel automatically selected and adaptively optimized
• Manual frequency mode : Yes
• Status LEDs : Power, Ethernet Link, RF RX, RF TX, 4/Channel, and 6/Link Quality
• MAC pass-through filter : Yes — can be disabled
• Error correction technique : Sub-block error detection and retransmission
• Adjacent-band rejection : SAW receiver filter attenuates cellular and pager interference
• Enclosure type : NEMA 4X
• Temperature range : -40o C to 70o C
• Power over Ethernet : Includes injectors/power supplies — 9 to 48 VDC ready