 |
 |
 |
|
The Bosch VideoJet X encoders belong to a family of industrial, high-performance, single-, dual-, or quad-input CCTV video encoders. They are built into a rugged housing and constructed to withstand extreme environmental conditions. The VideoJet X encoders may be used at extreme temperatures, operating from -30 °C to +60 °C (-22 °F to +140 °F). These powerful and flexible devices represent the cutting edge of high-performance Video-overIP for CCTV today.
Functions:
Rugged Environments:
VideoJet X encoders are ideal for outdoor applications such as perimeter, border, and fence control, as well as for industrial applications where they are tolerant of harsh environments. When used at remote locations you benefit from their wide 10 to 30 VDC power input range, so that they can be battery or solar powered. You also benefit from their SFP (small form-factor pluggable) slot that allows a direct connection to a fiber interface module without the need for external fiber hardware. Their industrial-grade vibration resistance makes these encoders extremely suitable for use in mobile applications such as trains, busses, or other vehicles.
Flexibility:
VideoJet X encoders offer unparalleled recording flexibility. Stream video across the network and store it using Network Video Recorders (NVRs). Record locally on CompactFlash, an external USB hard drive, or use an optional automotivegrade internal hard drive. Network-attached RAID iSCSI storage devices can also be used. The built-in iSCSI support enables the VideoJet X encoders to act as conventional DVRs while streaming high-performance live video across the network.
Dual Streaming:
The VideoJet X encoders use Dual Streaming to generate two independent IP video streams per channel if sufficient computational power is available. This allows viewing and recording at two different quality levels to save disk space and bandwidth. On alarm, they can send an e-mail with JPEG images attached.
Dual Recording:
You can record the streams independently on different media. Thus video can be recorded centrally on iSCSI drives managed by VRM Video Recording Manager and redundantly on the local media. If necessary, for example in case of a network failure VRM can fill up the gap in the central recording (ANR, Automatic Network Replenishment).
Recording Profiles:
The encoders feature a highly flexible recording scheduler, providing up to ten programmable recording profiles and allowing individually assigned camera profiles. With these profiles, you can accelerate the frame rate as well as increase the resolution on alarm, saving recording space during non-alarm periods.
Specifications:
Electrical:
Power supply: Via external unit or external battery
Input voltage: 10 to 30 VDC
Power consumption: X10: approx. 16 VA, fully equipped X20/X40: approx. 22 VA, fully equipped
Input/output:
Video: X10: 1 x input, X20: 2 x input, X40: 4 x input
Connector: BNC
Impedance: 75 ohm, switchable
Signal: Analog composite, 0.7 to 1.2 Vpp, NTSC or PAL
Audio:
X10: 1 x mono line in, 1 x mono line out
X20/X40: 2 x mono line in, 1 x mono line out
Connector: 2 x 3.5 mm stereo jack
Signal line in: 9 kohm typical, 5.5 Vpp max
Signal line out: 3.0 Vpp at 10 kohm / 1.7 Vpp at 16 ohm typical
Alarm: 4 x input
Connector: Clamp (non-isolated closing contact)
Activation resistance: 10 ohm max
Relay: 4 x output
Connector: Clamp
Signal: 30 Vpp (SELV), 2 A
COM port: Clamp, RS-232/422/485
Video:
Standards: H.264 Baseline Profile (ISO/IEC 14496-10) MPEG-4, M-JPEG, JPEG
Data rates: 9.6 kbps to 6 Mbps per channel
Resolution: Horizontal x vertical PAL/NTSC
Audio:
Standard G.711; 300 Hz to 3.4 kHz
Data rate 80 kbps at 8 kHz sampling rate
Network:
Ethernet: Dual port 10/100 Base-T, auto-sensing, half/full duplex, RJ45
SFP: 1 x 1 Gbps SFP (small form-factor pluggable) slot for optional standard SFP GBIC module
Protocols: RTP, Telnet, UDP, TCP, IP, HTTP, HTTPS, FTP, DHCP, IGMP V2/V3, ICMP, ARP, RTSP, SMTP, SNTP, SNMP (V1, MIB-II), 802.1x
Encryption: TLS 1.0, SSL, AES (optional)
Control:
Software update: Flash ROM, remote programmable
Configuration: Configuration Manager or Web browser
Connections:
Compact Flash: 1 x CF slot for optional standard Type I/II CompactFlash memory card
USB Ports: 2 x USB 2.0 high-speed ports, 2.5 W max feed each
Mechanical:
Dimensions (H x W x D): 61 x 160 x 178 mm (2.4 x 6.3 x 7.01 in)
Weight: Approx. 1.5 kg (3.3 lb) with HDD
Environmental:
Operating temperature: -30 °C to +60 °C (-22 °F to +140 °F) ambient temperature
Relative humidity: 0 to 95% atmospheric humidity, non-condensing
Thermal value: X10: 55 BTU/h max, fully equipped X20/X40: 75 BTU/h max, fully equipped
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Ruggedized for extended environmental conditions
- High-quality MPEG-4 video over IP
- H.264 Baseline Profile encoding
- Units with one, two, or four video inputs
- Built-in Intelligence-at-the-Edge
- Network-attached RAID storage via iSCSI
|
|
|
|
|
|
|
|
|
