Home > Shop Brands > Caddx >

  Caddx CA-GSMZWAVAT NetworX Alarm with Z-Wave AT&T

Caddx CA-GSMZWAVAT NetworX Alarm with Zwave AT&T


 

Our Price : $289.00


Product Code: CA-GSMZWAVAT

Qty:

Description
 
The NX-592E-GSM Wireless Gateway allows NetworX owners to control and monitor their system status from the Alarm.com website.

Through a wireless, two-way paging network, your customer has limited controls on such features as security, notifications, history, and authentication. The modem for the NX-592E-BO must be purchased separately from Alarm.com.

Utilizing the wireless paging network, NetworX owners may also be notified of system events by e-mail,
pager, or phone.

The wireless module interfaces with the NetworX panel data bus and is powered by the panel or an auxiliary 12
VDC power supply. Status LEDs indicate bus and paging network communications. for an illustration of the main module components, and see Table 1 on page 3 for a description of each component..

The wireless module interfaces with the NetworX panel data bus and is powered by the panel or an auxiliary 12 VDC power supply. Status LEDs indicate bus and GSM network communications.

Specifications:

Compatibility: NetworX panels.
Power requirements: 9.5 to 15 VDC, 12 V nominal, 65 mA (continuous), 1600 mA (instantaneous peak) maximum from panel or auxiliary power supply.
Paging network: One wireless, two-way paging transceiver (ReFLEX 25 for NX-592E-W or ReFLEX 50 for NX-592E-S).
Power/data bus: One three-wire NetworX power/communications data bus.
Indicators: One module/panel communication status LED. Four wireless communication status LEDs.
Operating temperature: 32 to 120F (0 to 49C).
Storage temperature: -30 to 140F (-34 to 60C).
Humidity: 90% relative humidity; non-condensing.
Case color: Belgian gray.
Case materials: High impact, ABS plastic.
Dimensions: 5.25 x 4.125 x 1 inch. (H x W x D).
Installation: Wall mount.
Features
  • NetworX panel (NX versions 4V2, 6V2, 8V2, 8E)
  • Alarm.com emPower-enabled GSM Module for NX (NX-592E-GSM-ZWAVE-AT or NX-592E-GSM-ZWAVE-TM)
  • Z-Wave peripherals to be installed
  • NetworX panels support a maximum of one Wireless Gateway per system.
  • Use four-conductor, 22- or 18-gauge stranded wire to connect the module to the panel Mount the module as close to the panel as possible. The module draws a maximum of 65 mA (continuous) and up to 1600 mA (instantaneous peaks) from the panel.
  • Do not exceed the panel's total output power when using panel power for bus devices and hardwired sensors (refer to specific panel installation instructions)

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Shop Brands > Caddx
Home Automation > Z-Wave Technology Products
 
 

Enter your email for a chance to WIN $100 Amex Gift Card.

Please Enter Your Email Address

*One entry per household please