Home > Audio / Video > Amplifiers >


Crown Audio CTs 3000 CTs Series Amplifier 120V 60Hz

Crown Audio CTs 3000 CTs Series Amplifier 120V 60Hz


Our Price : $2,263.08

UPC Code: 871015000275

Product Code: 505238


Building on the foundation of the Com-Tech® Series, Crown's CTs Series offers new flexibility and value for installed sound applications. The Com-Tech Series were the first to offer independent selection of high- and low-impedance operation for a specific channel, and CTs Series amplifiers continue that tradition, with power levels and features carefully chosen to perfectly integrate into fixed install design requirements.

  • High power density. All two channel models and four channel model in a 2RU chassis, eight channel model in a 3RU chassis
  • Crown Switching Power Supply for lighter weight
  • Selectable "Constant-Voltage" or low-impedance (4/8 ohm) operation per channel on 2-channel models, and per channel-pair on 4-and 8-channel models
  • 100V direct outputs on CTs 2000, CTs 3000, CTs 4200, and CTs 8200
  • Legendary Crown AB+B (Multi-Mode®) output topology in the CTs 600/1200 and Class I (BCA®) output topology in the CTs 2000/3000 offer the best in amplifier reliability
  • 4- and 8-channel models offer perfect independent power solutions for multi-zoned systems· "FIT" (Fault Isolation Topology) circuitry on 4- and 8-channel models isolates fault conditions without affecting neighboring channels
  • Two-channel models are fully PIP2-compatible. Multi-channel models accept MC accessory modules. • Switching Power Supply for reduced weight
    • High power-density, with all two-channel models in a 2U chassis
    • Direct constant-voltage (70V/100V/140V/200V) or low-impedance (2/4/8 ohm) operation
    • Input sensitivity independently selectable for each channel
    • TLC protection circuitry protects the amplifi er from long-term excessive heat by subtly and dynamically reducing the gain only when necessary
    • PIP2 (Programmable Input Processor) connector accepts accessory modules that tailor the amplifier to suit specific applications
    • Removable terminal block input connectors, with “Y” Input Switch in the standard PIP2-BBY module
    • Switchable high-pass filter for each channel provides low-frequency roll off to eliminate step down transformer saturation when used in distributed systems
    • Comprehensive array of indicators including Power, Data and Bridge, along with Ready, Signal, Clip, Thermal and Fault for each channel, provide accurate diagnostics
    • Blue Power Indicator flashes if the AC mains is under/ over voltage
    • Advanced protection circuitry guards against: shorted outputs, DC, mismatched loads, general overheating, under/over voltage, high-frequency overloads and internal faults
    • JTS circuitry (CTs 600/1200) quickly protects output transistors from unsafe operating conditions without shutting the channel down
    • Continuously variable fans optimize cooling efficiency
    • Three Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications
    • Crown’s advance-replacement Profit Protection Plan provides quick, no-questions-asked replacement of covered amps should they fail at any time up to 6 months following date of installation

  • Minimum Guaranteed Power: See power charts at left.
  • Frequency Response (at 1 watt, 20 Hz - 20 kHz): ±0.25 dB.
  • Signal to Noise Ratio below rated power (20 Hz to 20 kHz): 105 dB A-weighted.
  • Total Harmonic Distortion (THD) at full rated power, from 20 Hz to 20 kHz: CTs 600/1200: < 0.1%. CTs 2000/3000 < 0.35%.
  • Damping Factor: 10 Hz to 100 Hz: > 3000.
  • Crosstalk (below rated power, 20 Hz to 1 kHz): > 80 dB.
  • Common Mode Rejection (CMR) (20 Hz to 1 kHz): 50 dB.
  • DC Output Offset: < ±2 mV.
  • Input Impedance (nominal): 10 kilohms balanced, 5 kilohms unbalanced.
  • Maximum Input Level: +20 dBu before input compression, +32 dBu absolute maximum. Load Impedance: (Note: Safe with all types of loads.)
  • All models:
    Stereo: 2/4/8/16 ohms, 70V, 100V*.
    Bridge Mono: 4/8/16 ohms, 100V*, 140V, 200V*.

    *CTs 600 and CTs 1200 with T-170V or TP- 170V.

  • Share your knowledge of this product with other customers... Be the first to write a review

    Browse for more products in the same category as this item:

    Audio / Video > Amplifiers
    Shop Brands > Crown Audio > Amplifiers
    Shop Brands > Crown Audio

    Enter your email for a chance to WIN $100 Amex Gift Card.

    Please Enter Your Email Address

    *One entry per household please