 |
 |
 |
|
The XLS Series of power amplifiers from Crown represents a new era in affordable, quality power amplification. The line consists of four models in a uniform, rugged 2U chassis, incorporating the best of tried-andtrue design principles and innovative features. Plus, every XLS Series amplifier is backed by Crowns unequaled Three-Year, No-Fault, Fully-Transferable Warranty that covers everything. Features Reliable design incorporates many popular features Housed in a rugged, all-steel 2U chassis Efficient forced-air fans prevent excessive thermal buildup Electronically balanced XLR inputs; touchproof binding post and Speakon® outputs Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel. Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications Specifications
The following applies to units in Stereo mode with 8-ohm loads unless otherwise specified. Performance Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V. Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, –1 dB. Signal-to-Noise Ratio (20 Hz to 20 kHz, inputs terminated) A-weighted, below rated power: > 100 dB. No weighting, below rated power: > 95 dB. Total Harmonic Distortion (THD): < 0.5%. Intermodulation Distortion (IMD): (60 Hz and 7 kHz at 4:1) from full rated output to –40 dB: < 0.3%. Damping Factor (8 ohm) 10 Hz to 400 Hz: >200. Crosstalk (below rated power) at 1 kHz: –75 dB. at 20 kHz: –59 dB. Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced. Output Power: Load Impedance: Rated for 4 to 8 ohms per channel in Stereo, 8 ohms in Bridge Mono. AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC
|
|
|
 |
|
 |
|
|
|
