| One Timer Does It All! The EAGLE Model 1500 Programmable Relay Timer offers all the traditional timer functions plus unique features that add enormous versatility to the unit. The unit features two inter-dependent inputs, a 10-amp relay output (SPDT), an open collector transistor output offering an infinite array of timer application possibilities. An on-board LED indicates when the relay is active. AC or DC operation allows the timer to stand alone or work with an alarm panel. It’s slim, 1½ inch width, allows the unit to fit into most door jams. Programming is simple, utilizing a standard touch tone phone or serviceman’s test set. Activation of the primary trip input can be programmed to occur on the leading or falling edge of the activation. The Model 1500s operation is unique as the relay can be programmed to respond in a multitude of ways to the activation of the trip inputs. A sample of different programming modes includes: • Momentary relay activation. Ex. Exit-entry delay or door strike control. • Alternate relay activation/de-activation. Ex. Remote power switch. • Momentary relay activation with relay RESET from the Secondary trip input. (Door strike control with immediate strike release). • Timed delay before momentary relay activation with separate programmable momentary relay activation time. • Timed delay before relay activation with input follower. Relay follows the Main trip input after a timed delay. Secondary (open collector transistor) output activates 30 seconds before the timed delay expires which allows the use of an 8 ohm speaker to alert user. (Overhead garage door by-pass). • Timed delay before relay activation with delay RESET from the Secondary trip input. Secondary primary input after timers complete independent cycles. | (open collector transistor) output activates 30 minutes before the timed delay expires which allows the use of a PZT to alert user. (No activity timer). • Open collector output can be programmed to drive an 8 ohm speaker or an additional relay with programmable delay and activation times. • Generates a recurring trip after programmed period of time, with initial offset. (test signal generator) • Two independent timers with two outputs following FEATURES ♦ Normally open and/or closed 10 Amp relay output. ♦ Two activation inputs. ♦ One open collector transistor output. ♦ Fifteen (and growing) modes of operation. ♦ Status LED. ♦ Programmable modes of operation. ♦ Output depends upon input. ♦ Small footprint. ♦ Programmable time delay. 250ms to 99 days. ♦ Primary trip input on leading or falling edge. ♦ Relay activation: 10ms to 99 hours. ♦ Secondary output programmable as driver for a speaker or relay. ♦ AC or DC operation ♦ Initial start offset ♦ 0.012% accuracy APPLICATIONS ♦ Overhead garage door bypass (offers open status) ♦ Door strike control ♦ Remote power switch ♦ Exit-entry delay ♦ Convenience store back door bypass ♦ Daily, weekly or monthly test signal generation ♦ In-activity alarm ♦ ‘And’ function to perform ‘dual technology’ sensing SPECIFICATIONS Dimensions: 1.50” x 4.65” x 1” Power: Voltage: 12 to 24 VDC or 12 to 24 VAC Current (Standby/Active): 23 mA / 75 mA |
