The AM1 Appliance Module is a high quality plug-in home automation relay load controller that is capable of transmitting and receiving digital commands and status over the existing powerlines

The CEM-6 is a custom engraved membrane for the KPCW-6 and KPCD-6 6-Button Keypads. Each membrane button may be tailor labeled depending on which font; the font size between 2 and 19 characters may be etched on each button

The CEM-8 is a custom engraved membrane for the KPCW-8 and KPCD-8 8-Button Keypads. Each membrane button may be tailor labeled depending on which font; the font size between 2 and 19 characters may be etched on each button

The DBM Doorbell Ring Interface Module is a small plug-in device designed to sense the current of a doorbell ring to trigger the transmission of digital commands onto the existing powerlines.Send any UPB link command to turn on or off (or blink) any light or group of lights upon the ringing of a doorbell. Great for the hearing impaired

The Desktop Timer is a high quality home automation timer device that is capable of transmitting and receiving digital commands and status over the existing powerlines. Designed as a table top plug-in unit, it will t ransmit standard UPB commands at specified times of the day or upon a press of a push-button

The FMD Fixture Module Dimmer is a two channel high quality wire-in home automation light dimmer which is capable of transmitting and receiving digital commands and status over the existing powerlines.The FMD is the ideal solution to controlling incandescent lights or fixtures that need to be individually controlled or are not currently wired to a dedicated wall switch location

The FMR-1 Fixture Module Relay is a single channel high quality wire-in home automation non-dimming relay load controller which is capable of transmitting and receiving digital commands and status over the existing powerlines.The ideal solution for fluorescent lights, or other non-dimming loads (such as motors or transformers), that need to be individually controlled but are not currently wired to a dedicated wall switch location

The ICM Input Control Module is a high quality plug-in home automation interface device designed to transmit digital commands and status over the existing powerlines upon sensing low voltage or contact closure events.Perfect for interfacing off-the-shelf motion sensors, light sensors, occupancy sensors, pressure mats, RF remote controls, pushbuttons, etc. to the PulseWorx Lighting Control System

The ILC In-Line Choke is a small wire-in electronic device that is designed to be installed to keep electrical noise generated by certain electrical devices off of the powerline which interfere with the PulseWorx products? ability to communicate with one another

The IRR is a credit card sized infra-red remote control which reproduces all of the pushbuttons on the 6-Button Keypad Controller. Pressing a button on the IRR causes the KPCx-6 to perform the same action as if the same pushbutton were physically pressed on the KPCx-6