 |
 |
 |
|
Pelco's PMCQ14A is a versatile, easy to install, color quad monitor capable of simultaneous or sequential viewing of four video inputs. The monitor has four BNC inputs for cameras or VCRs. Front panel buttons on the monitor select a full-screen view of any video input or a multiple-screen view of all four inputs. The multiple-screen view can be either a quad display or a picture-in-picture (PIP) display.
The PIP display shows one input in full-screen mode and the other three inputs as insets. Other features allow you to sequence camera views, zoom in on a camera, and freeze a view on the monitor screen. Programming from the front panel lets you change the camera identification, time, and date that appear on the monitor screen. If you wish to record what is shown on the monitor screen, you can connect a VCR to a monitor output. If you prefer a more complete system, an optional camera designed specifically for this monitor is available. The camera includes a lens, mounting bracket, and 60-foot (18.3 m) cable. The camera can be purchased separately, or system kits are available with a monitor and 1-4 cameras. PMCQ14A Quad Monitor 14-INCH COLOR (NTSC) C1969 / REVISED 2-03 DataFAX SPEC: 21969 MANUAL: 219686 The optional camera adds additional versatility to the monitor.
The camera has a mini-DIN connector that plugs into a mating connector on the monitor. When this camera is used, this leaves the BNC video connector available for use as a looping output. The camera includes audio and alarm features. The audio feature lets the camera capture sound as well as video, and the alarm function allows alarm contacts to be connected to the camera rather than run all the way to the monitor. The audio and alarm combination also can be used as an intercom system. The alarm lets you install a "call" button near the camera so that a person on camera can get the attention of the observer. Built-in microphones and speakers on the camera and monitor permit the person on camera and the person watching the monitor to communicate verbally with each other. 12 VDC power for the camera is supplied through the min-DIN connector. The PMCQ14A makes full-color security monitoring an economical reality
Specifications:
Model: PMCQ14A: 14-inch color quad monitor
Electrical:
Input Voltage: 100 to 240 VAC, 50/60 Hz
Power Consumption: 70 watts
Signal Format: NTSC
Scanning System: 2:1 interlace
Picture Elements: 512 (H) X 492 (V)
Horizontal Resolution; 350 TV lines (center)
Linearity: Less than 12%
Total Geometric Distortion: <3%
Audio Output: 1.1 W ±0.2 W at 8-ohm resistive load
Pixel Format:
Single Screen: 720 (H) X 480 (V)
Quad Screen: 360 (H) X 240 (V)
PIP Screen: 208 (H) X 136 (V)
Refresh Rate: 30 frames per second (NTSC)
Digital Zoom: 2X
OSD Character:
16 X 20 bit map font (upper case alpha
characters, numbers, and symbols)
Video Switching: Time 1 second (during multiple alarms)
Maximum Character
Display Format: 45 (H) X 24 (V) (1,080 characters)
General:
Picture Tube: 14-inch diagonal color
Controls: Sharpness, color, brightness, contrast, tint, and volume
Character Display: 8 alphanumeric characters for each camera, date, time, alarm, video loss, and freeze
Display Modes: One camera, four cameras (quad), picture-inpicture (PIP), and VCR
Sequential Switching Mode: Set dwell time from 1 to 30 seconds; OFF setting skips channel
Video Loss Detection: All channels
Time Mode: 12-hour mode with AM/PM indicator
Alarm Inputs: 4, activated by N.O. or N.C. contact closure (programmable)
Alarm Output: 1, common to all 4 inputs. TTL compatible (programmable for high or low output)
Alarm Beep: On or off (programmable)
Automatic Alarm: Reset Set reset time from 1 to 60 seconds; OFF setting defeats auto reset (programmable)
Impedance Termination: 75 ohms or bridging for 4 video inputs (from cameras) and 1 monitor output
Dimensions: 12.75" H x 13.68" W x 14.68" D (32.38 x 34.75 x 37.29 cm)
Unit Weight: 28.6 lb (13 kg)
Shipping Weight; 32 lb (14.5 kg)
Environmental:
Operating Temperature: 32° to 104°F (0° to 40°C)
Storage Temperature: 4° to 158°F (-20° to 70°C)
Humidity: 35% to 80%, non-condensing
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Four Video Inputs for Cameras or VCRs
- Single-Camera or Four-Camera Displays
- Camera Sequencing with Programmable Dwell Time for Each
- Camera
- Alarm Inputs for Each Camera
- Video Output for Recording
- Alarm Output to Trigger VCR
- 2X Digital Zoom and Freeze Functions
- Camera ID, and Date and Time Displays
- Video Loss Detection
- Optional Camera with Audio Available
|
|
|
|
|
|
|
|
|
