5895XL Intelligent Power Module
The intelligent way to distribute power throughout your installation
With 5.0 amps of output power, six programmable Flexput I/O circuits, and two Form C relay circuits, the Model 5895XL Intelligent Power Module allows you to greatly enhance the capabilities of an IntelliKnight system, distributing power where needed throughout a facility.
5895XL modules connect via the RS 485 system bus. Up to eight 5895XL modules can be used per IntelliKnight system. Each 5895XL has its own optically isolated RS 485 bus to which other modules, such as 5860 remote annunciators and 5824 printer interface modules, can be connected. You can also connect 5815XL SLC expansion modules, adding flexibility and wiring distance. Each 5895XL supports its own backup batteries and monitors the AC power.
The green LED on the 5895XL board indicates communication with the IntelliKnight FACP. The six Flexput I/O circuits can be notification appliance circuits, continuous power, resettable power, door holder power, or initiation circuits that can support both 2- and 4-wire smoke detectors. All Flexput I/O circuits and relay outputs are individually mappable from the IntelliKnight 5820XL FACP.
5.0A output power
6 I/O circuits, 3A each, programmable as notification circuits, auxiliary circuits, or initiation circuits.
2 Form C programmable relays rated at 2.5A at 24 VDC
Ground loop isolation
SBUS repeater conditions the RS 485 signal
6,000 feet wiring distance from the 5895XL (same distance as main FACP)
Large cabinet can house two 17 amp hour batteries
UL 864 Listed, complies with NFPA 72 and 101
Primary AC: 120 VRMS at 60 hz, 2.5A
Total Accessory Load: 5A at 24 VDC
I/O Circuit Power: 3A per system (5A total per system)
Dimensions: 16"W x 26"H x 4.65"D (40.6cm W x 67cm H x 11.8cm D)
Mounting: Surface or flush