 |
 |
 |
|
Terminus Shock Sensors SP3227 Recessed Shock Sensors let you offer your customers proven shock sensor technology in a small, flush-mounted package.
Terminus Shock Detection Systems consist of Terminus Shock Sensors and Processors.
The shock sensors can be mounted on almost any structure such as
windows, walls, roofs, safes, vaults, ATMs, and night depositories. The
Shock Sensor Processors work with all alarm panels and can monitor up
to 50 Shock Sensors per zone. The Terminus Shock Sensor works where
many fail, due to its unique dual-activated control system that signals
an alarm.. When an intruder approaches or touches the perimeter, his or
her shock waves cause the dual elements to momentarily bounce off
reliable, gold-plated electrical contacts. An open circuit then sends a
signal to a Terminus Processor. The Processor analyzes and reports its
status to the main alarm control panel so the intruder can be detected
earlier.
The key advantage to Terminus Shock Detection Systems is their ability alert customers of an entry attempt before the intruder enters a secure area
unlike conventional interior protection which doesnt send an alert
until after the area has been breached. Theres no more effective way
to safeguard merchandise, equipment, sales, and business.
The Terminus Fence Intrusion Detection Systems allow
Terminus Shock Sensors to become part of a fence perimeter to signal an
alarm when someone climbs, cuts, or lifts the fence fabric or posts.
Each kit contains a shock sensor, a molded insert, and a condulet
housing. Terminus Shock Sensors have been used on thousands of miles of
outdoor chain link fence and reliably detect intrusions in even the
most extreme temperature conditions. These rugged kits are successfully
protecting thousands of miles outdoor chain link fence in temperatures
as low as 40 below zero and as high as 160 degrees F.
Terminus Recessed Shock Sensors let you offer your customers proven shock sensor technology in a small, flush-mounted package.
The SP3227 dual element Recessed Shock Sensor is installed flush with a window or door frame, so it remains unnoticed as it provides superior perimeter protection. The sensor flange can be painted to blend with any decor, so its perfect for residential applications, and for commercial installations where appearance is particularly important. The SP3227 may also be used in pre-wire applications. Since the sensor is recessed in the window frame, it will not be damaged during completion of construction.
In both the surface mounted SP3237 and the recessed SP3227, two sets of contacts must be activated simultaneously to signal an alarm.
This dual contact technology reduces false alarms caused by failure of the single contact. All metal components in the hermetically sealed sensor are gold plated, eliminating corrosion from liquid or vapor contaminants.
Perimeter Protection
Lets your customer know of an entry attempt before the intruder enters a secured area - not after, as an interior protection does. The system can be armed while the area is occupied.
Compact Measures just 3/4" in diameter x 1" in depth.
UL Listed to U.S. safety standards.
Versatile Mounting
The SP3227 may be mounted on the side, top or bottom of a window frame, and can be used with wood or metal window frames. Simply drill a 3/4" hole in the widow frame and connect the two-wire lead to the sensor loop. Push the sensor into place. The sensor is not polarity sensitive. Four raised ribs wedge the sensor into the window frame to assure a tight fit.
The Terminus Family
The SP3227 is compatible with all Terminus processors. Area coverage and sensitivity is the same as the standard SP3237. Both the recessed SP3227 and the surface mounted SP3237 may be installed in the same processor loop. Please refer to the Terminus Perimeter Shock Detection Manual for further details.
Ten Year Warranty Every Terminus Shock Sensor is covered under a ten year limited warranty against defects in materials and workmanship.
|
|
|
 |
|
 |
|
|
|
