You are here: Home > Shop Brands > On-Q / Legrand > Power
We found 20 results matching your criteria.
Sort By:
Page of 2
On-Q / Legrand 364266-01 Power Strip Module - Full Width On-Q / Legrand 364477-01 A-Bus Power Supply 24VDC -  DISCONTINUED REPLACED BY 364529-01
Four outlet 110VAC power strip with on/off switch, built-in circuit breaker, and power LED indicator.

(Formerly OnQ Technologies)

On-Q / Legrand 364477-01 A-Bus Power Supply 24VDC - DISCONTINUED REPLACED BY 364529-01
On-Q / Legrand 364727-01  Multiswitch 5X8 Power Supply On-Q / Legrand 364771-01 Power Surge Protector
On-Q / Legrand 364727-01 Multiswitch 5X8 Power Supply Onq H4-364771-01 Surge Protector
On-Q / Legrand CX16APS Individual Power Supply - 1 Outlet On-Q / Legrand F7639 Multi-Voltage Power Distribution Module - DISCONTINUED REPLACED BY PW7639
On-Q / Legrand CX16APS Individual Power Supply - 1 Outlet DISCONTINUED REPLACED BY PW7639
On-Q / Legrand F7723 24V 2.9AMP Power Supply On-Q / Legrand F7725 12V, 25 Amp Desktop Power Supply
The F7723 provides 24 Volt, 2.5 Amp power for the lyriQ Audio Module for uninterrupted listening pleasure. But it's more than just a power supply. Noise can be introduced into an audio system through the electrical outlet powering the system. The F7723 provides noise-filtration to the incoming power, providing clean power throughout the distributed audio system.

This 12 Volt power supply is the best solution for powering a large Cat 5 Intercom System (9 or more Room Units and Door Units combined). This power supply provides up to 2.5 amps of current which is plenty of power to support a fully loaded Cat 5 Intercom System.

This power supply provides a regulated output of 12 volts DC with low ripple. It features built in overcurrent and short circuit protection as well as an internal primary current fuse.

Features

  • 12 Volt, 2.5 Amp
  • Regulated Output with Low Ripple
  • Meets Safety Agency Requirements
  • CE Compliant
  • Impact Resistant Polycarbonate Enclosure
  • Built-in overcurrent and short circuit protection
  • Internal primary current fuse


    Specifications


    Transformer Dimensions: 3.74 (L) X 2.13 (W) X 1.26 (H)
    Power Output: 12V DC, 2.50 amps maximum
    Output Type: Regulated with low ripple
    Power Input: North American style, 100-250V AC,
    line frequency = 47 - 63 Hz
    Protection: Input = internal primary current fuse, Inrush limiting
    Output = overcurrent and short circuit protectection


  • Edwards Signals ED-EG1C Signaling Chime 24Vdc In White Edwards Signals ED-EG1CVM Chime Strobe Hi To Low Adjustable White
    Edwards Signals ED-EG1C Signaling Chime 24Vdc In White


    The Genesis line of signals are the smallest, most compact audible-visual signaling devices in the world. Genesis chimes and chime strobes blend with any decor and feature textured housings in neutral white or traditional fire alarm red. Genesis strobes do not require bulky specular reflectors. Instead, an exclusive mask-and-cavity design channels and conditions light to produce a highly controllable distribution pattern. Intensive development efforts employing this new technology have given rise to a new benchmark in strobe performance--FullLight technology. This technology produces a smooth light distribution pattern without the spikes and voids characteristic of specular reflectors. This ensures the entire coverage area receives consistent illumination from the strobe flash. Genesis strobes are self-synchronizing, but when installed with an optional synchronization modules, strobe flashes from devices on the same circuit synchronize to within 10 milliseconds of each other indefinitely. Chime/Strobes feature 15, 30 , 75 or 110 candela output, selectable with a conveniently-located switch on the bottom of the device. Settings are clearly visible even after installation. Genesis chimes produce a pleasing mellow tone. When steady (non-stroked) voltage is applied, the chime automatically pulses at 60 strokes per minute, or may be field-configured for temporal output. When installed with an EG1M Signal Master Module, the chime may also be field-configured for coded operation, which enables the chime output to match the rate that voltage is applied to the circuit. The chime's 79 dBA (peak) output level makes this device suitable for many private mode applications. Chimes may be set for low dB output with a jumper cut that reduces sound output by about 5 dB.

    Edwards Signals ED-EG1CVM Chime Strobe Hi To Low Adjustable White


    The Genesis line of signals are the smallest, most compact audible-visual signaling devices in the world. Genesis chimes and chime strobes blend with any decor and feature textured housings in neutral white or traditional fire alarm red. Genesis strobes do not require bulky specular reflectors. Instead, an exclusive mask-and-cavity design channels and conditions light to produce a highly controllable distribution pattern. Intensive development efforts employing this new technology have given rise to a new benchmark in strobe performance--FullLight technology. This technology produces a smooth light distribution pattern without the spikes and voids characteristic of specular reflectors. This ensures the entire coverage area receives consistent illumination from the strobe flash. Genesis strobes are self-synchronizing, but when installed with an optional synchronization modules, strobe flashes from devices on the same circuit synchronize to within 10 milliseconds of each other indefinitely. Chime/Strobes feature 15, 30 , 75 or 110 candela output, selectable with a conveniently-located switch on the bottom of the device. Settings are clearly visible even after installation. Genesis chimes produce a pleasing mellow tone. When steady (non-stroked) voltage is applied, the chime automatically pulses at 60 strokes per minute, or may be field-configured for temporal output. When installed with an EG1M Signal Master Module, the chime may also be field-configured for coded operation, which enables the chime output to match the rate that voltage is applied to the circuit. The chime's 79 dBA (peak) output level makes this device suitable for many private mode applications. Chimes may be set for low dB output with a jumper cut that reduces sound output by about 5 dB.

    Edwards Signals ED-EG1FCVM Chime Strobe Hi Low White With Fire Edwards Signals ED-EG1RCVM Chime Strobe Red Adjustable
    Edwards Signals ED-EG1FCVM Chime Strobe Hi Low White With Fire


    The Genesis line of signals are the smallest, most compact audible-visual signaling devices in the world. Genesis chimes and chime strobes blend with any decor and feature textured housings in neutral white or traditional fire alarm red. Genesis strobes do not require bulky specular reflectors. Instead, an exclusive mask-and-cavity design channels and conditions light to produce a highly controllable distribution pattern. Intensive development efforts employing this new technology have given rise to a new benchmark in strobe performance--FullLight technology. This technology produces a smooth light distribution pattern without the spikes and voids characteristic of specular reflectors. This ensures the entire coverage area receives consistent illumination from the strobe flash. Genesis strobes are self-synchronizing, but when installed with an optional synchronization modules, strobe flashes from devices on the same circuit synchronize to within 10 milliseconds of each other indefinitely. Chime/Strobes feature 15, 30 , 75 or 110 candela output, selectable with a conveniently-located switch on the bottom of the device. Settings are clearly visible even after installation. Genesis chimes produce a pleasing mellow tone. When steady (non-stroked) voltage is applied, the chime automatically pulses at 60 strokes per minute, or may be field-configured for temporal output. When installed with an EG1M Signal Master Module, the chime may also be field-configured for coded operation, which enables the chime output to match the rate that voltage is applied to the circuit. The chime's 79 dBA (peak) output level makes this device suitable for many private mode applications. Chimes may be set for low dB output with a jumper cut that reduces sound output by about 5 dB.

    Edwards Signals ED-EG1RCVM Chime Strobe Red Adjustable


    The Genesis line of signals are the smallest, most compact audible and visible emergency signaling devices in the world. About the size of a deck of playing cards, these devices are designed to blend with any building environment. Edwards Genesis horn/strobes do not require bulky specular reflectors. Instead, an exclusive mask-and-cavity design, channels and conditions light to produce a highly controllable distribution pattern. Intensive development employing this new technology have given rise to a new benchmark in strobe performance--FullLight technology. The EG1-HDVM series horn/strobes offer 15 to 110 candela output,l which is selectable with a conveniently-located switch on the side of the device. The EG1-HDVMH series offers 95 to 177 candela output. The candela output setting remains clearly visible even after final installation, yet it stays locked in place to prevent unauthorized tampering. Its horn output reaches as high as 99 dB and features a unique multiple frequency tone that results in excellent wall penetration and an unmistakable warning of danger. Horns may be configured for either coded or non-coded signal circuits. They can also be set for low dB output with a jumper cut that reduces horn output by 5 dB. When installed with the Cat. No. EG1M Signal Master, strobe flashes from devices on the same circuit are synchronized to within 10 milliseconds of each other indefinitely. The Signal Master also permits independent horn control over a single pair of wires. Only one Signal Master is required per circuit. No separate backbox--simply snap it onto the back of the first signal on the circuit.

       
     
     
     

    Enter your email for a chance to WIN $100 Amex Gift Card.

    Please Enter Your Email Address

    *One entry per household please